It takes about 2 hours to fully charge the Bluetooth Headset. If you haven’t used the headset for a while, the battery could have a reduced capacity and may need fully recharging more than once.
Note: Before you start using your Bluetooth Headset, you must charge it for approximately 8 hours to reach the battery's maximum capacity.
The connection you set up when you pair the phone and the Bluetooth headset is specific between those two devices. When you change phone or Headset you must always repeat the pairing procedure to specify the connection for these devices.
When you pair the Bluetooth Headset with a phone, the headset is added to the phone's list of paired Bluetooth devices. When you subsequently turn the headset on, the phone will automatically recognise the headset. If you've paired the phone with more than one Bluetooth device, you must choose which device you want to connect your phone to from the phone's list of Bluetooth devices.
Before you start, make sure your phone supports voice commands.
To start using voice commands (for detailed instructions, see the phone's user's guide): 1. Prepare your phone by activating the voice command function. 2. Record your voice commands. When you've done this, you'll be able to use voice commands with the headset and the phone.
Note: Do the recording in a normal environment. Check that the phone numbers are saved correctly (for example, home number under "Home", etc.).
Remove the earhook from the headset and flip it to make it fit the other ear. Then put it back on and make sure it's attached to the headset correctly. For further instructions, please refer to the User Guide.
When you reset the settings in the headset, the headset will go into default mode (as it left the factory, before being used). This means the pairings you've made to other Bluetooth devices no longer exist.
You can reset your headset when, for example, you start using a new phone with your headset and you no longer want to use the old phone.