1. Turn on the Bluetooth function in your phone. For instructions, please see the phone’s user guide.
2. Turn on Bluetooth™ visibility in your phone, to make your phone visible to other Bluetooth™ devices.
3. On the watch, select Pairing mode (by pressing the bottom key 4 times to reach the pairing mode icon).
4. Press the top key to turn pairing mode on. The Pairing mode icon is shown and the watch vibrates.
5. Press “Yes” when Add device? appears in your phone. If asked for it, enter the passcode (usually “0000”).
6. When the pairing is successful, the pairing icon is shown and the watch vibrates.

1. Connect the charger to the charging clip, with the symbols facing in the same direction.
2. Connect the charging clip to the left side of the watch, by pressing the clip to open it and then sliding it over the watch. Make sure that the clip contacts are connected to the watch contacts.
3. The charging symbol is displayed. The watch is fully charged when the battery indicates that charging is complete, after approximately 2 hours.
4. Remove the charging clip.

Your device has a level 3 ATM resistance to water. This means that the watch will withstand splashes of water or light rain. You should not wear it while bathing, showering, swimming or during any water sport activities.

1. Press the bottom key on the watch to choose a function.
2. Press the top key to switch the function on or off. An "x" next to the icon means the function is switched off.

• Bluetooth™ functionality: up to 7 days
• Analogue time keeping: up to 7 additional days

1. Press the bottom key once to enter the menu.
2. The Bluetooth™ icon is highlighted. If there is an "x" next to the icon, the Bluetooth™ function is turned off.
3. Press the top key once to turn on the Bluetooth™ function (the "x" will disappear).

1. Press the bottom key on the watch to choose the function (icon showing an envelope).
2. An "x" next to the icon means the function is switched off. Press the top key to switch the function on.

• K610
• K610im
• K618
• K790
• K800
• V630
• W710
• W850
• Z610
• Z710

1. Pull out the crown gently.
2. Rotate it to set the correct time.
3. Press the crown in until you hear a click.Note:If you don’t press the crown in until you hear the click, the watch may start to run slow and not show the correct time.